First build parts help

[tuisk]

Hi,

I'm totally new to quadcopters but want to build my own and have been looking online at different guides and searching for different parts on hobbyking. I would like to build something cheap to start off with but with room to expand it in the future.
I would eventually like it to have a range of up to 2km, flight time of 10 minutes at least and FPV.

This is a list of the parts I was thinking about buying to start off:

Frame:
http://www.hobbyking.com/hobbyking/...opter_Frame_450mm_Integrated_PCB_Version.html

ESC:
http://www.hobbyking.com/hobbyking/..._Motor_Speed_Controller_SimonK_Firmware_.html

Motor and propellers:
http://www.hobbyking.com/hobbyking/..._Motor_and_Propeller_Combo_10x4_5_CW_CCW.html

Battery:
http://www.hobbyking.com/hobbyking/store/__8934__Turnigy_2200mAh_3S_25C_Lipo_Pack.html

Flight controller:
http://www.hobbyking.com/hobbyking/...ntroller_With_Cable_Set_Fully_Authorized.html

Transmitter and receiver:
http://www.hobbyking.com/hobbyking/..._Module_8ch_Receiver_Mode_1_v2_Firmware_.html


I am wondering would this be a good build to start off with or if someone could offer me alternate suggestions for parts it would be much appreciated.

Thanks

 

[GJH105775]

Your battery isa bit small, both in capacity and amp output(55-amps_supply:60-amps_draw). This has a amp output of 52amp/105amp output, they sell both a 3S2P and a 3S1P version of the same battery hahaha

I'd suggest you get the 3S1P one as it is a little lighter and skinnier.


Other than that everything looks pretty good, have you considered gettting the KK2.1.5 or APM?