Escs wont arm

[Samussays]

built my first quad, Castle escs readymade 2300kv motors kiss fc spektrum dx8 transmitter spektrum spm 4648 rx everything went good but the escs wont arm I can arm the quad bust nothing from the motors so I thought I may have used some incompatible parts so I built a second one blheli escs e maxx motors naze 32 rev 6 fc and guess what exactly same result the only thing that is the same between them is the rx so I can't help but think it's a TX setting but I have no idea please help I'm going nuts

 

[KC27]

Had this issue not to long ago. Found out my throttle was inverted.

 

[holtneil]

Hi mate I second that the esc needs to see zero throttle and a rudder input to arm make sure the board on the set up is seeing zero throttle

 

[Wildwelder]

Yup sounds like a software problem more than a hardware one. Look over your arming technique and like KC said, verify if your throttle needs to be inverted. Love the fact that you built another just to see if it worked..... youre as crazy as I am! Love it

 

[Tic FPV]

Hi Samussays,

I'm building my first quad and have the same problems as you had here, all ready 3 days on it without any luck.
Have you find your problem? If yes it could help me very much to have the solution.

Thanks
Eric

built my first quad, Castle escs readymade 2300kv motors kiss fc spektrum dx8 transmitter spektrum spm 4648 rx everything went good but the escs wont arm I can arm the quad bust nothing from the motors so I thought I may have used some incompatible parts so I built a second one blheli escs e maxx motors naze 32 rev 6 fc and guess what exactly same result the only thing that is the same between them is the rx so I can't help but think it's a TX setting but I have no idea please help I'm going nuts