Eachine Racer250 and FS TH9x

[dcruze]

I am trying to set up the Eachine Racer 250 with a FS Th9X transmitter using a FrSky D4R-II 4 channel receiver. This is the setup that I use for my 3DR Iris+ and I would like to be able to use the same transmitter for both.


Is this combination possible, or do I need a different receiver?


I see a lot of people using this copter, but I am having trouble finding information on getting it to work. Any help is appreciated. Thanks.

 

[Jackson]

Gotta jump thru a few hoops.

http://uavspeak.com/how-to/lumenier-qav250-build-part-3/

 

[dcruze]

Thanks, I think part of my problem is that the Eachine Racer 250 requires a 6 channel receiver and I was trying to use a 4 channel. I order a new receiver. We will see it that makes things easier.

 

[Jackson]

is that the Eachine Racer 250 requires a 6 channel receiver

Not really.

That said.

FrSky D4R-II 4ch

• 2 full length antennas (replaceable)
• One external analog telemetry port and one digital data-stream port (connect to Sensor Hub FSH-01)
• RSSI (PWM) and CPPM output - If CH3 and CH4 are connected by a jumper, CH1 will output RSSI (PWM), and CH2 will output CPPM for CH1~CH8

 

[dcruze]

That's how I had it set up, with the jumper and using the CPPM, but I couldn't get any response from the controller while I was setting up the software. I will investigate and see if maybe on of my wires needs reversed or something. I'm not sure which direction to go with this.

 

[Jackson]

So you followed the instructions and altered the 3 wire connector?

 

[dcruze]

Oh.. maybe that's the part I missed. I will go back and check on that. Thanks.

 

[dcruze]

I still have to check on that wire, but do you know if I have a Lipo Battery that reads 1500 mAh 3S 11.1V 25C can I replace it with one that reads 1500 mAh 3S 11.1V 35C. I know that 25C or 35C has something to do with Amperage. Will 35C burn something up?

 

[Jackson]

Will 35C burn something up?

No.