Luna Prey
Member
Hello everyone. I'm building my first quad! It has a Spectrum FPV Racing Serial Receiver, and a SP F3 Racing controller. It also has Cleanflight installed and I can control the motors from the Cleanflight software!
When I bind my DX6e controller to it, it connects and says 11ms, and the light on the receiver turns solid orange, but there is no bars showing on the receiver like there is when I bind to my other drone. Also, when I move the controls I am unable to see any changes inside the receiver tab in the Cleanflight software.
So to conclude... the light on the receiver turns solid orange, and it says it connects on the controller, but it doesn't seem to actually connect, the motors don't respond, and I don't see any evidence it's connected from inside CleanFlight.
Also, not sure if relevant, but it says DSMX on the top left of the controller. Usually when I connect to my other drone (that works) it says DSMX on the top left, and on the top it says the connection bars. In this situation it shows no connection bars.
Can anyone please offer any advice?
When I bind my DX6e controller to it, it connects and says 11ms, and the light on the receiver turns solid orange, but there is no bars showing on the receiver like there is when I bind to my other drone. Also, when I move the controls I am unable to see any changes inside the receiver tab in the Cleanflight software.
So to conclude... the light on the receiver turns solid orange, and it says it connects on the controller, but it doesn't seem to actually connect, the motors don't respond, and I don't see any evidence it's connected from inside CleanFlight.
Also, not sure if relevant, but it says DSMX on the top left of the controller. Usually when I connect to my other drone (that works) it says DSMX on the top left, and on the top it says the connection bars. In this situation it shows no connection bars.
Can anyone please offer any advice?
Last edited: