Drone Throttle Drift Issue with Walkera 110 Rodeo

[Mr 2rbo]

Hey Guys. Newbie to drones checking in. I recently purchased a walkera rodeo 110 rtf for my first drone. I noticed that it has a slight backwards throttle drift. I hooked it up to clean flight and noticed the accelerometers weren't calibrated correctly so I reset the calibration, but I am still getting the same problem. I have to push throttle slightly forward to get drone to hover correctly.

I was wondering if anyone could give me a couple tips on what I can do/check to fix this issue?

 

[holtneil]

Hi mate are you sure its the throttle and not a drift on the cyclic ( right stick in mode 2 set up ) , go into clean flight and check all sticks read zero , untill an input is put in then it should show this input and in the direction its moved in

 

[Mr 2rbo]

Hi mate are you sure its the throttle and not a drift on the cyclic ( right stick in mode 2 set up ) , go into clean flight and check all sticks read zero , untill an input is put in then it should show this input and in the direction its moved in

Hey Holtneil thanks for the reply. I can't seem to figure out how to check my stick input. I went to the receiver tab but I don't see any changes anywhere when I have stick input.

 

[Mr 2rbo]

Ah just figured it out. I needed to put in my battery for it to bind, and now I see my pitch is at 1482 instead of 1510 like everything else.

 

[holtneil]

Hi that will make it roll in a hover its like a stick input all the time