does anyone know the location of the sd card on my jjrc h8d quadcopter

[magic man]

hi
im new at this but i was was told that you have to take the camera apart to take out the sd card to review on my computer
is that correct ?
is there a easier way to view my photos
can anyone answer this

 

[holtneil]

Hi Mate the board on the camera does not have a port for a USB lead , they dont do it as its a cost thing they make it cheap and simple

 

[magic man]

So does that mean
I can not review any videos that I take
And if so how do I do it
Thank you so much for your reply
Magic man

 

[Mike H.]

Yours may or may not have come with the SD card..The card would click in and out somewhere from the exterior of the camera..there should be a slot for the card ...With the 2.0mp camera, a 2gb card would be sufficient to use with it if yours didnt come with one.

 

[magic man]

Thank you
I finally found the SD card on the side of the camera. I didn't see it before
Another question
I have no rudder control
Tried the trim ad with no luck
What's next
Thanks

 

[Mike H.]

Hard to say really...is it in the proper mode?..have you calibrated the flight board?

You should have throttle and Yaw on the left stick,..Pitch and roll on the right.

 

[magic man]

What is the proper way to calibrate thus unit

 

[Mike H.]

I would check youtube on that..Maybe try "how to calibrate a JJRC H8D"..See what shows up..Its a very simple procedure..Involves a few movements of the sticks and the quad being on level ground.

 

[Mike H.]

Try this.

1. Plug the battery in on the quad.
2. Immediately place on flat, level surface
3. Wait about 10 seconds for gyros to initialize.
4. Turn on transmitter, move left stick up and down until you hear a beep.
5. Set transmitter to 100% rate mode.
6. Move both sticks to lower-left corner, and hold their for 10 seconds
7. Release sticks, wait three seconds and try flying.

 

[magic man]

thank you for all your help

 

[magic man]

have a syma x5c and it flew great for about a week
now after charging battery shows 4.28 and copter wont get off the ground also one motor not turning
could that be because of the battery?