MickyMous
New Member
First off, the set up...
Hobby King 2.4Ghz 4Ch Tx & Rx V2 (Mode 2)
Hobbyking X650F Glass Fiber Quadcopter Frame 550mm
HobbyKing Multi-Rotor Control Board V3.0 (Atmega328 PA)
Q Brain 4 x 20A Brushless Quadcopter ESC 2-4S 3A SBEC
4 x NTM Prop Drive Series 28-30A 750KV / 140W
12x4.5 SF Props 2pc Standard Rotation/2 pc RH Rotation (Red)
Turnigy nano-tech 3300mah 2S 25~50C Lipo Pack
Now, my problem seems to be my control board. After a little research I figured out the ESC programming and the Q-Brain seems to work fine when plugged directly to the Rx, BUT as soon as I hook up the control board that is supposed to be pre-flashed with + set up all I get is a 3 note tune then a single beep. There is no response from anything after that.
Can anyone help who has had similar issues or a similar setup that worked? It would be greatly appreciated. Even if your advice is a different control board, I can return mine and buy a new one easily.
Hobby King 2.4Ghz 4Ch Tx & Rx V2 (Mode 2)
Hobbyking X650F Glass Fiber Quadcopter Frame 550mm
HobbyKing Multi-Rotor Control Board V3.0 (Atmega328 PA)
Q Brain 4 x 20A Brushless Quadcopter ESC 2-4S 3A SBEC
4 x NTM Prop Drive Series 28-30A 750KV / 140W
12x4.5 SF Props 2pc Standard Rotation/2 pc RH Rotation (Red)
Turnigy nano-tech 3300mah 2S 25~50C Lipo Pack
Now, my problem seems to be my control board. After a little research I figured out the ESC programming and the Q-Brain seems to work fine when plugged directly to the Rx, BUT as soon as I hook up the control board that is supposed to be pre-flashed with + set up all I get is a 3 note tune then a single beep. There is no response from anything after that.
Can anyone help who has had similar issues or a similar setup that worked? It would be greatly appreciated. Even if your advice is a different control board, I can return mine and buy a new one easily.