Circuit design for short-circuting outputs when needed

A

April155

Member
I am working with two sensors with 4 pin as output.
My question is simple: I want to make circuit that allows me to short circuit the output of either one of the sensors individually when needed.

I am considering using quad 1:2 demux (AGD774a) and shorting either the pins on channel B together while measuring with channel A and vice versa.
So when I want the channel for normal measurement I will use channel A and when I want output of sensor shorted I change the channel of the switch.

So, my main question is whether using a demux to solve the requirement is a wise choice or there is some other way it can be achieved.

Notes:

  • The sensor is an ultrasonic transducer which produces only millivolt level outputs.

    In use the sensor is placed in a heating chamber to increase its temperature.
    When the temperature of the transducer is varied, it produces spurious temperature-change related voltages.
    After heating we need to short the output pins to release all the residual voltage.
    The charge itself is small.

    May be I can do a worst case calculations and attach a resistance as well with it.

  • Temperature Sensors, Transducers Temperature Sensors, Transducers are in stock at Kynix Electronics. Kynix offers inventory, pricing, & datasheets for Temperature Sensors, Transducers. To know more, please view our large section of Temperature Sensors, Transducers below.
  • The voltage drop is small - in the mV range.
    I do not think that an electromechanical relay is required.

  • The sensor will not be connected to Micro-Controller.
    Shorting is needed to discharge the piezo in the sensor which occurs when the temperature is changed.
 
GJH105775

GJH105775

Off and on
Moderator
April155 said:
I am working with two sensors with 4 pin as output.
My question is simple: I want to make circuit that allows me to short circuit the output of either one of the sensors individually when needed.

I am considering using quad 1:2 demux (AGD774a) and shorting either the pins on channel B together while measuring with channel A and vice versa.
So when I want the channel for normal measurement I will use channel A and when I want output of sensor shorted I change the channel of the switch.

So, my main question is whether using a demux to solve the requirement is a wise choice or there is some other way it can be achieved.

Notes:

  • The sensor is an ultrasonic transducer which produces only millivolt level outputs.

    In use the sensor is placed in a heating chamber to increase its temperature.
    When the temperature of the transducer is varied, it produces spurious temperature-change related voltages.
    After heating we need to short the output pins to release all the residual voltage.
    The charge itself is small.

    May be I can do a worst case calculations and attach a resistance as well with it.

  • Temperature Sensors, Transducers Temperature Sensors, Transducers are in stock at Kynix Electronics. Kynix offers inventory, pricing, & datasheets for Temperature Sensors, Transducers. To know more, please view our large section of Temperature Sensors, Transducers below.
  • The voltage drop is small - in the mV range.
    I do not think that an electromechanical relay is required.

  • The sensor will not be connected to Micro-Controller.
    Shorting is needed to discharge the piezo in the sensor which occurs when the temperature is changed.
Click to expand...
Can't you just use two MOSFETS in series, or a Transistor to short it to ground (through a resistor if needed)?
 
You must log in or register to reply here.
Top