Can someome please check over my parts list

[Chester (newbie)]

If there are any obvious mistakes I have made, or items that need to be added to the list, please do say. Also if there is anything I could change to keep costs down, also please do say. This is my essential parts list for my Quadcopter... In the future I will add FPV, but for the meantime, to keep costs down, I am only worried about the main parts. Any comments/help would be kindly appreciated!

Flight controller - DJI NAZA M-LITE WITH GPS - http://www.ebay.co.uk/itm/251898393891?_trksid=p2055119.m1438.l2649&ssPageName=STRK:MEBIDX:IT

Frame - HobbyKing Q450 http://www.hobbyking.com/hobbyking/...opter_Frame_450mm_Integrated_PCB_Version.html

Landing extensions- cheap off of Hobbyking, but out of stock at the moment.

Battery- Multistar 3s 5200 lipo pack - http://www.hobbyking.com/hobbyking/...apacity_3S_5200mAh_Multi_Rotor_Lipo_Pack.html

Controller (Transmitter) - Turnigy 9Ch http://www.hobbyking.com/hobbyking/..._Module_8ch_Receiver_Mode_1_v2_Firmware_.html

Speed Controller x 4 - HobbyKing 30A blue series - http://www.hobbyking.com/hobbyking/...0A_BlueSeries_Brushless_Speed_Controller.html

Motors x 4 - NTM Prop drive - http://www.hobbyking.com/hobbyking/...00W_Brushless_Motor_short_shaft_version_.html

CARBON FIBRE PROPELLORS -
http://www.hobbyking.com/hobbyking/..._DJI_Phantom_CW_and_CCW_Rotation_1_pair_.html

BATTERY CHARGER, - ANY RECCOMENDATIONS? AGAIN DONT WANT IT TO BE EXPENSIVE, JUST A NORMAL CHARGER..

If I have missed anything blatantly obvious..... Please do tell me as I do need to order these parts soon! Thanks guys in advance!

 

[holtneil]

Hi mate sorry But the motors wont give you a good lift on 8 inch props , the test was done with a 4 cell battery and 6 cell, and 8 inch prop
on a 3 cell I would look more at 10x 4.5 or 10 x4.7
A 30 amp esc will be good but get ones that are simonk flashed they work well with NTM motors
your also need male to male servo leads to connect receiver to the naza
heat shrink and xt60 and wire for the PDB on the frame, and prop mounts for the NTM