calibrating escs

Discussion in 'First Build' started by Nathan Moore, Mar 11, 2019.

  1. Nathan Moore

    Nathan Moore New Member

    For a class project, I have been working on a drone that someone had already made trying to set up mission planner on it. I have calibrated everything except the escs. I have followed a lot of tutorials but nothing happens. The motors just keep beeping every time its plugged in. The flight controller is a pixhawk and it has a 4 in 1 esc. WIN_20190307_07_58_39_Pro.jpg
     
  2. Dugdog47

    Dugdog47 Well-Known Member

    Check make sure you don't have any screws touching the motor windings and also check the solder joints on escs make sure there are no shorts.
     
    GJH105775 likes this.
  3. RENOV8R

    RENOV8R Well-Known Member

    What model of 4-in-1 ESC are you using?
     
  4. Christ1@n

    Christ1@n Member

    Interesting. Following.
     

Share This Page