Beginning Build

[techno20]

This is my first time building a quadcopter. I have researched a for a while and this is what I have come up with:
Frame: HobbyKing 250FPV SMACK Premium
ESC: Emax SImonk Series 12A
Flight Controller: MWC MultiWii SE V3.0
Motors: DYS Be1806 2300KV
Batteries: Turnigy 3000maH 3s 11.1v 30C
Props: Gemfan 5030

Do all of these components work together and is there anything else I need? I am trying to keep my price range between $100-$200 but I still want it to be of a good quality.

 

[GJH105775]

Can you provide links to both the ESCs and motors?, what do you plan for power distribution, nad does the battery have a yellow XT60 connector?

 

[techno20]

Can you provide links to both the ESCs and motors?, what do you plan for power distribution, nad does the battery have a yellow XT60 connector?

ESC
Motors

For the power distribution I was planning on getting this, and the battery does have a yellow XT60 connector (I accidentally listed the wrong battery).
Thanks!

 

[GJH105775]

This PDB comes with the female xt60 connector.

I'd suggest these motors, but if you can't afford them these are from hobbyking for about the same price as yours.

Also I would suggest you get two of these batteries, or two of something a little smaller. These are much cheaper and more respected than the ones in your link, and you could get better flight times.

 

[techno20]

Is the frame okay for all this stuff? Is there enough space for this and maybe in the future FPV equipment? And what would you recommend for a cheap yet good quality Tx/controller?

 

[GJH105775]

I'd say the Turnigy 9X, if you have the extra money the 9XR (almost $100). If you are about broke then the hobbyking HKTR6A is fine.

Check this FPV setup I recommend.

Is the frame okay for all this stuff? Is there enough space for this and maybe in the future FPV equipment? And what would you recommend for a cheap yet good quality Tx/controller?