Arris 250 w/ radiolink at9. Um, how do I turn it on?

K

Kung Fu Carl

New Member
Okay, I'm not an idiot, but I'm an idiot. Ha ha, actually I'm an aircraft heavy structures mechanic, so the fact that I cant figure out how to make the rotor blades spin via the AT9 controller is, well, it's frustrating.

Yes power is on.

Yes, on both the controller and RC.

And while we're at it, is there a manual for this thing? That will instruct me how to engage the engines/ change the light pattern/ et cetera?

Oh, and this is not a home build. It came assembled and calibrated, both the controller and rc.

Thanks,
Mechanically Humbled in Texas.
 
Last edited:
It's using a CC3D I think. You should have provided a link to exact quad you got.

Turn on transmitter then the quad's RX. Pull the throttle stick down then right, if that don't do it try down then left.
 
Thanks man. As it turns out I DID have to run through the Open Source process. Then follow your instructions. Yep - I'm an idiot! Ha ha ha.
 
How is it going with the Arris, I put mine on the shelf I cannot get the setting to the point where I can fly without crashing. I have two others which fly fine but the arris just dives to the ground and there is no recovery. I think I am going to change out the controller, the current one does not seem to respond to programming like others that I have used. This is Openpilot, and I really don't like their software configuration.
 
Jackson said:
It's using a CC3D I think. You should have provided a link to exact quad you got.

Turn on transmitter then the quad's RX. Pull the throttle stick down then right, if that don't do it try down then left.
Click to expand...
ERRR, what is the RX you refer too? I also am a NOOB.
 
You must log in or register to reply here.
Back
Top