I posted a thread earlier that has since been resolved. The current issue was resolved, but the main project still has not been completed. I almost had my Quadcopter fully completed until I short circuited my Naze32 board. So I bought 3 more boards off amazon for $30. Hopefully I didn't get ripped off.
While I wait, I figured I try and connect the quadcopter to an Arduino Uno Board. The problem is I'm following The Schematic posted below. My motors are connected to ESCs without BEC. From my understanding that means it only has a ground wire and a signal wire. I do have a voltage converter that is connected to my PDB along with the motors and battery. How can I modify the schematic for my specific type of motors. I notice that all other google images only post pictures of Arduino Unos with BEC ESCs. Noob mistake I suppose :\. Also, is there a schematic for Raspberry Pis with the same scenario? Thank you again for any guidance or step toward the right direction!
While I wait, I figured I try and connect the quadcopter to an Arduino Uno Board. The problem is I'm following The Schematic posted below. My motors are connected to ESCs without BEC. From my understanding that means it only has a ground wire and a signal wire. I do have a voltage converter that is connected to my PDB along with the motors and battery. How can I modify the schematic for my specific type of motors. I notice that all other google images only post pictures of Arduino Unos with BEC ESCs. Noob mistake I suppose :\. Also, is there a schematic for Raspberry Pis with the same scenario? Thank you again for any guidance or step toward the right direction!