Apm 2.8 tunning

shaun21

shaun21

Member
I have installed firmware to the flight controller, do I need to tune the apm 2.8 or do I need to make changes in PID settings, because quad is not taking flight properlly.
 
I rely on Painless 360 a lot. His tutorials are excellent and easy to understand. This might help with your tuning
 
Im using the apm 2.8, been trying for days to get it set up, seemed to work at first, but couldnt get the motors to arm, noticed on radio calibration the throttle seemed to be backwards, push stick up, green bar went down, push stick down green bar goes up, ive removed the software from my computer and reinstalled several times, even reset the board, now it wont even upload the firmware, wen selecting the comport it doesnt identify as arduino it just says "serial device", im running windows 10, any suggestions?
 
You must log in or register to reply here.
Back
Top