Anyone know the basic wire setup for a CC3D to a FrSKY X8R receiver?
- Thread starter irishluck
- Start date
You mentioned that your receiver cuts out as well when the lipo is running low?
Well Im kinda confused because my battery was fully charged when It did this. I turned the throttle on just enough to get the props spinning and thats when I noticed that
the receiver green light was blinking on and off randomly. Along with the motors slowing down and spinning back up randomly.
Well Im kinda confused because my battery was fully charged when It did this. I turned the throttle on just enough to get the props spinning and thats when I noticed that
the receiver green light was blinking on and off randomly. Along with the motors slowing down and spinning back up randomly.
cookie1985
Active Member
Yeah mine did it when lipos were low, i was running a 1000 test battery, so i noticed it, i also found that the receiver went into standby (best way) to describe, might be the same thing, i noticed this when i was testing props via cc3d.
I would then have to touch controls, then it would come online.
I would then have to touch controls, then it would come online.