newb

Hi I was hoping someone can help me with my problem. I have a SHRC H1 quadcopter that's experiencing a problem. I follow the instructions to the letter. WITH CONTROLLER: • turn on drone and place on a level service. The lights underneath the drone flash very quickly. • turn on controller, lights...

this forum has been unhelpful. Delete this thread

In my previous thread I asked for help because my quad was flipping off of take off. This turned out to be that the FCB was pointing the wrong way in the quad so I had to change the direction in betflight to point forward. Now the quad matches the betaflight diagram when I tilt and turn it but...

Hello all, This is a link to a video I took of it happening: I'm using a link to the YouTube because this website wont let me upload the video. I made sure the propellers were all on the right motors and in betaflight I checked each individual motor to make sure they were turning the right...

Hey guys, so I got a wizard ARF in the mail a couple months ago and I still haven't been able to get it flying yet. This was my first drone, and I know I dove in way over my head, I had a sharp learning curve and finally have a better understanding of it all, but I'm at a stand still and I'm not...

Hello folks, I'm Shane Retired US Army SGT who lives in Louisiana with my family. I have one 5YO Son and he begged me for a Quad for Xmas. I purchased him and his friend each 1 Nat Geo Quadcopter Drone with Alt Hold and Headless mode. So far so good other than the Neighbor Friend took his up out...

Hi guys, First post here and I certainly hope it isn't too dumb :( Basically I've been around quadcopters for the past few years but have never been too serious, just some fun backyard flying and maybe a little bit of fpv using immersion tx/rx and a home made ground station. Well now I've...

I'm using a CC3D board with 30AMP Afro Simonk ESC's and Sunny Sky motors. In the setup wizard what settings do I use PWM, PPM, OneShot, and have no idea what any of those stand for. I'm using a T-FHSS 8-channel Futaba Receiver. Every time I go through the setup wizard and plug in the battery the...

hey guys I'm in high school and for my engineering project I'm making A quad. I'm using 1000kv motors, the hobbyking tx and rx, a 5400 mah battery, 30a escs and the kk2.1.5. I calibrated the escs and heard some music so I think it's all synced together but I noticed some stuff when trying to...

I don't know how to delete a thread XD