issues

I'm having issues with my quadcopter's motors. I'm using Racestar BR 2205 brushless motors, but when I mount them to the frame and test the motors in Cleanflight, they spin slowly and make a rubbing/grinding like noise (I'll attach a video). But when I unscrew the motor from the frame and test...

Just bought this new Syma X5HW unpacked and assembled it and I was soo excited, but the kill joy here was when I tried to synch it with the transmitter/controller(Up-Down) the X5HW's leds still blinks while the Controller's light is steady?Is this busted or I'm missing something?Oh and the...

I have the AT9 Transmitter and I am trying to set up an external receiver using the R9DS receiver. I can not use the built in FRSKY receiver because the AT9 can only bind to Radiolink receivers.... However, I having issues getting flight controller binded to the transmitter. The receiver is...

Good Day, today i finished the building process of my new quadcopter. Naze32 Rev6 Full S550 Frame 30A SimonK Esc 100KV Motors 1045 Props So the building part is done, all is neat and like i want. I started the calibration and the initial setup. Flashing Naze etc. I use a Turnigy 9xr...

My first build is a 250 with a CC3D flight controller and a FS-t6 transmitter/corresponding receiver. I have been able to successfully calibrate the quad using the libre pilot software. However once i get to the transmitter setup wizard i cant successfully setup the transmitter. The software...

So I recently built a quad and since I first started up the motors I noticed the back left motor stops almost instantly when I kill the throttle. To the touch it seems as though the magnets are a tiny bit stronger but it still allows me to spin it freely. I want to know if there is a simple fix...

Whilst shooting this video with our amazing phantom 3 professional we had a problem with the gimbal's x-axis stabilization. We simply made it work by turning the drone off and back on. From there everything was fine. Do you have any idea on how this has happened? Anyways in this video two...

Hi guys, I need some help. I have built my 2nd quad, its a Diatone 200. The quad is fully built and care has been taken to ensure the soldering in clean and everything very well insulated. I have used spaces and electrical tape to insulate the board from the frame and heat shrink for the...

Aloha Guys, I have just recently my first Quad kit, I have played with plenty of store bought drones and a Hubson X4 but this is my first kit. Below is a link to the clone kit I purchased. http://www.amazon.com/gp/product/B010FMGUS8?psc=1&redirect=true&ref_=oh_aui_detailpage_o03_s00 Here is...