Search results

  1. S

    Power Supply for Charger. Help.

    Cheers for your help anyway .
  2. S

    Power Supply for Charger. Help.

    Thanks. Does this have the power to allow the charger to charge a 6s 10000mah lipo at 10Amps?
  3. S

    Power Supply for Charger. Help.

    Hi there, I am thinking of investing in a Turnigy Reaktor 300W charger to charge my 6s 10,000mah lipo. However, I can't find a power supply. It says that to acheive full power it needs an input voltage of >18v. I then roughly calculated that if a power supply outputted 18V at 20Amps, the...
  4. S

    Naza m v2 voltage problem?

    Thanks for the advice, much appreciated.
  5. S

    Naza m v2 voltage problem?

    Hi there, I am looking for some advice! I am using a 6s 10000mah 22.2v lipo with a DJI naza m v2, for my setup. My battery is brand new and the first time I connected it to fly, I calibrated the naza's voltage meter to the battery's current voltage, 23.0 volts. I then set the warning voltage to...
  6. S

    Components?

    Thanks for the advice.
  7. S

    Components?

    Thanks. I see what you mean about the motors. I had not read the info carefully enough. Its actually a hexacopter frame that I am planning on creating: "tarot 680 pro". I am hoping to use DJI Naza v2 FCB. The other esc I had seen was the: DYS 30A 2-4S Brushless Speed Controller ESC Simonk...
  8. S

    Components?

    I am planning to make a new multirotor. After some research, I am planning to buy these components: -ZTW spider series Opto 30Amp esc -Sunnysky V3508 580KV motors with 13*5.5 props. I was wondering if these would work best with either two 5000Mah 3S lipo's running in parallel, or one 6200mah 6c...
  9. S

    SOLVED: Quadcopter Does Not Respond to Elevator When Self-Level is On

    Thanks, Increased the PI limits and it works great.
  10. S

    SOLVED: Quadcopter Does Not Respond to Elevator When Self-Level is On

    Hi, I have just built a quad copter and am using a kk2 flight control board.When the self level feature is turned on, the quad copter does not move forward when the elevator control stick is moved, the only response that sometimes occurs is that it wobbles uncontrollably and loses altitude very...
  11. S

    Which ESC and Battery Should I use?

    Thanks. That was really helpful.
  12. S

    Which ESC and Battery Should I use?

    Hello, I am a relative beginner with quad copters but nevertheless I am building one for a project at school. I have purchased some A2212/13T 1000Kv motors. On a test on you tube, the highest amperage supplied to the motor was 14Amps. I was planning to buy a Turnigy Lipo 2200mAh 3S 11.1v...
Top