Search results

  1. K

    Pixhawk on Geprc LC7HD frame

    As topic quoted, does pixhawk flight controller (liked 2.48 and latest 6c) could be fit inside Geprc 7 inhces HD frame along with skyroid receiver? Thanks.
  2. K

    Difficult to fly in pilot sight of view or FPV

    Yes, agreed. My drone camera's was always keep me coming to see upon the sky(That is why I always failed into ground with unforeseen terrain). Is that possible to have drone stay in 45 angle instead of place in horizontal ground, then it will make my fpv's view to have seen more clearly on...
  3. K

    Difficult to fly in pilot sight of view or FPV

    There is no problem to fly in LOS (Line of Sight) but It is totally difficult to fly in Pilot sight of view aka FPV and I always ended to flip over on first until three seconds. I'd attached a picture and what is it called from those highlighted in red circle (watermark?), does it help to...
  4. K

    How to fly like a PRO

    Yea, I'd adjust all the settings to keep under range from 1000 : 2000. Hope It would be find later after real time trial flight :).
  5. K

    How to fly like a PRO

    ok, I'll keep mind.
  6. K

    How to fly like a PRO

    That is why I'd trying to adjust my "Radio's Output" to have yaw, pitch, roll with middle's endpoint set to 1500 along -70 % and + 70 % (Suit to me as beginner to behave press commonly the stick but actually produce lower 70 % output than actual 100 %). Besides that, I set my throttle starting...
  7. K

    How to fly like a PRO

    I've try to undertand and follow the same on this video but this is a tinywhood, but I still do drifted onto left side after calibrated accel under my flight mode = Angle + Air mode.
  8. K

    How to fly like a PRO

    I'd go far to test from just now. It also very difficult to pitch to fly forward and always dift to the left. I'm using Angle Mode + Air Mode (permanet enabled). Pitch Forward not working in real flight, need more help, TQ.
  9. K

    Aux 5 not working on betaflight

    I do watch from his video before where you need to adjust offset values to get close to each other for under AUX 1. That say if I do share Turtle's (AUX 6) with GPS rescue mode, is it possible to work?
  10. K

    Aux 5 not working on betaflight

    Yes, you are right and It is all about depending on receiver. FYI, I'm using Frysky R9 slim plus OTA under FCC type in FLEX FPORT firmware. I'd done checking from Fryskiy sites and it could supports upto "6/16 channel" with telemetry. What is means?
  11. K

    How to fly like a PRO

    Yes, you are right. We need to prepare the spare parts for esc, prop, motor (I'd managed to put back metal magnet insider before and adjust back in position and seems to be work well) even another ready to fly drone as I learned from expert before.
  12. K

    How to fly like a PRO

    Yes, you rights too. There is no easy to learn in acrobatic mode. It is been a lot of hilarious failing schemes happened againts me in past few days under my few maiden flights. Few Example liked Hard to maintain altitude, throttle to jump high and various uncontrol scenarios.
  13. K

    How to fly like a PRO

    Yes, you are right. I need to tried first time on acro mode. I finally beter understand I need to coupe with angle mode + air mode liked always the same working in Sim.
  14. K

    Aux 5 not working on betaflight

    I'd tried to create GPS recues Mode on Radio's (AUX 10) with Betaflight (AUX 5), but It won't work. Betaflight seems to be support until channel 4 (AUX 4) and not more. Below is my Input & Mixer againts betaflight ( Working ) Arm (Radio - AUX 5) - AUX 1 (Betaflight) Turtle Mode (Radio - Aux...
  15. K

    How to fly like a PRO

    I'm experienced difficult to fly in real life instead of gaming in simulation (There is no problem to fly in liftoff for me). I'd no idea to fly in step forward by holding pitch after weared in FPV googles even without wearing fpv googles. My quad just always hover to the left and ended up to...
  16. K

    Does my prop setup in properly?

    That is easy, I'd just change "Yaw degree" to 90 (can be 180, 270) degree for FC alignment (Configuration tab of betaflight), since my VBAT + & - (Battery Terminal) shifted to left side, I'd also manage to change resource motor to correct direction (CLI command : set resource motor 1 XX)...
  17. K

    FPV google display black screen after play a while without power on

    Yes, You are totally right. I'd finally found the root cause of problem. My Camera's solder of 5 volt supply point din't working after test with voltmeter (near to my FC's Video In & Out solder point). I managed to solder my camera's 5 volt input to other 5 volt supply point, but everything...
  18. K

    FPV google display black screen after play a while without power on

    Does i need to "power on" fpv google before quad? It seems to be black screen from google after I play a while on my 5 inches drone without google before I plug the power to turn on the fpv google. It just showing RSSI 99 % and battery voltage level only. Why? FYI, I'm using AKK FX2...
  19. K

    Does my prop setup in properly?

    problem fix, I'd everything good to go. BTW, TQ for your reply.
Top