Search results

  1. M

    where does cc3d get power from ?

    I thought i put a link on that post , link ( ill try again ,,) I have salvaged a connector from an old esc and powered the fc from my bench psu and all is working fine .. thanks for all your help..
  2. M

    where does cc3d get power from ?

    Thanks for the help , i have ordered some of these (BEC's) . So whats the idea of having 4 seperate +5 v feeds ?
  3. M

    where does cc3d get power from ?

    Hi , i have replaced all the esc's on my black widow drone , but i think i made an error when buying the esc's , am i right in thinking the cc3d fc gets its power from the esc then sends power on to the receiver ? . The esc's i took off had 3 wires each going to the fc and the new ones only have...
  4. M

    advice for which esc to replace this burnt out one .

    Ok , i will change all 4 , would the racerstar 35amp Dugdog47 suggested allow for possible motor upgrade in the future too ? . also the motor of the burnt esc looks like the windings have got a bit hot , there is a photo in the pics i linked in the first post ( the last one) . i am a bit...
  5. M

    advice for which esc to replace this burnt out one .

    Thanks for the reply , the motors are 2204-2300kv if that helps , and would i need to replace all the esc's ?
  6. M

    advice for which esc to replace this burnt out one .

    Hi , i have been thinking for a while about getting a fpv racing drone so decided to go the cheaper route and get one to fix up , i got a Black Widow Drone ,Cyclops Goggles And Turningy Controller for not a bad price (i think) which " just needs an esc to get it flying" . The esc is badly burned...
  7. M

    mavic pro crash ,motor or esc to blame.

    pilot error ! , not sure how i stopped the rear left motor from spinning
  8. M

    mavic pro crash ,motor or esc to blame.

    It wont start without both compasses , so it seems .
  9. M

    mavic pro crash ,motor or esc to blame.

    I have not tried it yet , i am waiting for the GPS/compass module to turn up , im just trying to understand what went wrong .
  10. M

    mavic pro crash ,motor or esc to blame.

    No , no warranty or insurance , i sent logs to DJI , they just want me to send it for repair which will cost a small fortune no doubt , its almost repaired i'm just not sure if i need to change the esc
  11. M

    mavic pro crash ,motor or esc to blame.

    Hi all , i had my mavic pro crash recently due to the rear left motor stopping looking at the logs iit appeared the motor was still getting voltage but the current dropped , in testing the motor it seemed a little tighter to turn than the others but spinning it ant testing the output voltage it...
  12. M

    hubsan transmitter battery mod advice

    Ahh yes , I see there’s an led on the buck covertor on , , the board does say 4-13 volts , I thought i thought the battery would last longer and be less heat using the buck .. Could I just wire the main switch before the converter ?
  13. M

    hubsan transmitter battery mod advice

    Hi all , i recently did a lipo battery conversion on my H107D+ transmitter , i also installed a buck converter and set it to 6 v (same as 4 x AA's) it was all working well . I have just tried to turn it on after a week or so of no use but the lipo is dead flat .. have i missed something ...
Top