Search results

In the end I gave it a try with the following config: M1: CW with 1045R M2: CCW with 1045 M3: CW with 1045R M4: CCW with 1045 Sadly,my copter is still not flying. I assume the motors just aren't powerful enough. I also notice that sometimes one of the motors just stops of a moment. This migh...

Hey! I finally got my props :-) Now I have to install them. As I have 1045 and 1045R props, can you advise where it should put the 1045 and where the 1045R? I have an X configuration, with the top rotors turning to eachother, and the bottom turning away from eachother... Should I use the 1045R...

Ok :-) Thanks for the clarification! It is not easy to come by propellers over here it seems... I ordered before the following 10x4.5, as I suspected already that my 7 inch would be a bit too small... I think they contain both CW and CCW props (called 1045 & 1045R). I am sad that I will have to...

This btw is how it looks now, the wires I have put away in the mean while :-)

Thanks! I had put the motors 1 & 3 clockwise and 2 & 4 counterclockwise. I understand that there is no such thing as a special (counter)clockwise propeller? Sadly, my quadcopter stays put :-( I also performed the calibration of the ESC. Am I correct to understand it is normal that motor 1 & 3...

Hey! I have built myself a quadcopter, but still have some rather basic questions as it seems not to be willing to fly… Maybe it’s best to start with the exact configuration I used: 1x Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver 1x Hobbyking KK2.1HC Multi-Rotor Hard Case Flight...