Recent content by Spinrb8

Yes, they are the same as shown on the top 5

Yes, I'm getting the same thing. I have a feeling I don't have the radio programed right. I never set up angle or horizon modes. No worries, if I can't get it I'll take it down the street to some local guys (friendly hobbies)and see what they think.

When I check the box I bring the slider up to max then when I plug my battery in it goes chip chip chip chip until I bring the slider back down then it gives a few different beeps ad quits.

When I do like the video shows I get a repetitive beep and the motors barely twitch with each beep.

Yes, that and the magnetometer.

Dang, I just deleted my last post. would it have anything to do with self leveling? I only did the two calibrations in setup.

I'm giving up on it for a couple of days so my hair can start growing back. Thanks so much for your help! I'll post back when I get it figured out.

To save us both the headache I think I'll just order another FC without all these wire harnesses.

Okay, yeah everything is moving right in the receiver tab just not getting anything from AUX1. If I go to modes and click add range under Arm I get nothing when I flip my Channel 5 switch. Maybe I need to use other wire harness labeled with inputs instead of using the receiver harness labeled AUX.?

I'm putting the fc wire labeled throttle into channel 1 in the receiver even though its the 3rd wire coming from the board. Is this correct or should I plug the fc wires in order into the receiver making channel 3 throttle?

What says throttle on the diagram I put into 1 on the receiver. Then A into 2, E into 3 and R into channel 4. Then aux 1 is in channel 5 and so forth.

After I enter map I get AETR1234

I have a Dragonfly32 compact with all the wire harnesses, which I regret buying. I have my receiver hooked to the receiver harness and my motors plugged into pins. When I go to clean flight it recognizes my two sticks and I can control the motors through cleanflight.

Ok, I managed to add switch SG to my 5th channel. When I go to Cleanflight it doesn't recognize it in either the modes tab or receiver tab. Thanks so much for your help!