Search results

Yes, they are the same as shown on the top 5

Yes, I'm getting the same thing. I have a feeling I don't have the radio programed right. I never set up angle or horizon modes. No worries, if I can't get it I'll take it down the street to some local guys (friendly hobbies)and see what they think.

When I check the box I bring the slider up to max then when I plug my battery in it goes chip chip chip chip until I bring the slider back down then it gives a few different beeps ad quits.

When I do like the video shows I get a repetitive beep and the motors barely twitch with each beep.

Yes, that and the magnetometer.

Dang, I just deleted my last post. would it have anything to do with self leveling? I only did the two calibrations in setup.

I'm giving up on it for a couple of days so my hair can start growing back. Thanks so much for your help! I'll post back when I get it figured out.

To save us both the headache I think I'll just order another FC without all these wire harnesses.

Okay, yeah everything is moving right in the receiver tab just not getting anything from AUX1. If I go to modes and click add range under Arm I get nothing when I flip my Channel 5 switch. Maybe I need to use other wire harness labeled with inputs instead of using the receiver harness labeled AUX.?

I'm putting the fc wire labeled throttle into channel 1 in the receiver even though its the 3rd wire coming from the board. Is this correct or should I plug the fc wires in order into the receiver making channel 3 throttle?

What says throttle on the diagram I put into 1 on the receiver. Then A into 2, E into 3 and R into channel 4. Then aux 1 is in channel 5 and so forth.

After I enter map I get AETR1234

I have a Dragonfly32 compact with all the wire harnesses, which I regret buying. I have my receiver hooked to the receiver harness and my motors plugged into pins. When I go to clean flight it recognizes my two sticks and I can control the motors through cleanflight.

Ok, I managed to add switch SG to my 5th channel. When I go to Cleanflight it doesn't recognize it in either the modes tab or receiver tab. Thanks so much for your help!

Great, Thanks!

I have a Taranis X9D plus transmitter and have no idea on how to set it up to arm my quadcopter. I've searched for days and I'm not getting anything that a beginner would comprehend. I'm using or trying to use Cleanflight. Thanks to anyone that can help me.

Yes, I'm pretty good with soldering. I've been building RC cars and trucks for about 30 years so I have some experience with soldering but not a ton. I didn't get any straight or angled pins with my FC or my PDB. I'm starting to wonder about TeamLegit. Multi rotor has the Dragonfly 32 compact...

After going to your link for multirotormania it looks like they call it a Dragonfly32 Compact and not a pro plus. Also looks like out of all these wires it comes with I'll still need to solder the motors direct anyway lol.

I wish I had bought just the pro instead of the pro plus. It would have been easier to solder the posts and plug right in instead of splicing 50 wires. Thanks to your post I should be able to cross reference and get it figured out a lot easier. I didn't get much help from Team Legit...