Recent content by Spin

Thank you, gentlemen. I know the question was quite vague, and I apologize. Just not experienced enough to put it in better terms. Do I understand that it would be better to adjust the FC rather than install a smaller prop and risk lowering efficiency and run time? If so I definitely need to...

Say we have a quad that is simply to fast and agile for our current skill level. We don't want to spend the money for lower voltage batteries to slow the quad down a bit. Can we just use smaller props? Looking at prop data, different props will turn at different speeds on the same motor at the...

Thank you so very much! Will be back as I slowly make progress.

Motors were $40. Everywhere I searched everyone complained about the price, never the quality. No one ever said they wouldn't buy them again. Saw 3s listed once or twice, but didn't save the locations. Understand the current and speed will be 33% larger, may tentatively try 3s someday. Receiver...

Building a Morphite 180 V2 with TMotor MT1306-10 3100 kv, Rotorgeeks 12A ESC with BLHeli (1 with BEC), AfroMini 32 (Ver 3), FrSky D4R-II (setup as PPM), GemFan 4x4.5 nylon glass fiber props, and a 1300maH 2S 7.4V battery. I need 5V for the receiver. Is it as simple as a servo cable from the...