I have a qav 250, currently I use 3s 11.1v lipo, I get about 5 min of flying time, how can I increase flying time and how big of battery can this qav250 can handle?
Any thoughts,
smoked
Thank you, I will set it up when I get all of it and post some video or pictures. My FPV is all on budget so I bough "Eachine VR-007" googles. As I saw in youtube video, it looks like a killer deal for a beginner.
Smokey
Hello All,
I have Naze 32 board, what ports are the one next USB and how to tap power for camera. I want a FPV setup and ordered camera and needs power camera and transmitter.
Please see the image attached to this post
Thanks again!
Smokey
Renov8R takes it all by himself to winning circle. Yes my QUAD was flipped 180, I changed as per instructions and changed idling speed for all props and it is flying like before atleast. Check the video of it flying now
Thank you , thank you, thank you
Smokey
I turned the RC control stick all the way up and I plug the battery of the quad, I get 3 chimes and I pulled the throttle to low position and I did not hear anything or see any change. I disconnected the battery and reconnected and armed but no change in the way it behaves.
Smokey
How do I arm my controller if I disconnect the battery. when I disconnect, it disconnects form controller right and when I connect back I have to arm by moving my yaw stick right. Confused
Smokey
I think my arrow on the board is facing backwards meaning rear of the quad. How do I tune it to face correctly. Please see the attached picture.
Smokey
What I noticed on bench is that when I try to pus the thrust, right front and rear left are starting first and half throttle all motors run and I checked the yaw, when give half throttle and do left yaw, left front motor and rear right motor spins which I assume is correct and it does vice...
Yes, I did run through sensor calibration, I swear I used to fly with the same setup for a while and it started act like this only after I connected to open pilot and updated the firmware.
Smokey
Hmm, My props all look correct like you showed in the picture. I think my ESCs are not calibrated properly and I noticed when setting my idle, front left always needs higher number to start. I tried to sync all ESCs several time but nothing is fixing it. I keep breaking props by flipping and...