Search results

1500 mah and more mah will increase weight right which is my issue Smokey

I have a qav 250, currently I use 3s 11.1v lipo, I get about 5 min of flying time, how can I increase flying time and how big of battery can this qav250 can handle? Any thoughts, smoked

Thank you, I will set it up when I get all of it and post some video or pictures. My FPV is all on budget so I bough "Eachine VR-007" googles. As I saw in youtube video, it looks like a killer deal for a beginner. Smokey

Here is the link to my camera https://www.amazon.com/gp/product/B00WJFKXS8/ref=oh_aui_detailpage_o02_s00?ie=UTF8&th=1 Smokey

Hello All, I have Naze 32 board, what ports are the one next USB and how to tap power for camera. I want a FPV setup and ordered camera and needs power camera and transmitter. Please see the image attached to this post Thanks again! Smokey

Renov8R takes it all by himself to winning circle. Yes my QUAD was flipped 180, I changed as per instructions and changed idling speed for all props and it is flying like before atleast. Check the video of it flying now Thank you , thank you, thank you Smokey

I turned the RC control stick all the way up and I plug the battery of the quad, I get 3 chimes and I pulled the throttle to low position and I did not hear anything or see any change. I disconnected the battery and reconnected and armed but no change in the way it behaves. Smokey

I followed the procedure and when I move the throttle down, I do not get any chimes. Smokey

How do I arm my controller if I disconnect the battery. when I disconnect, it disconnects form controller right and when I connect back I have to arm by moving my yaw stick right. Confused Smokey

I think my arrow on the board is facing backwards meaning rear of the quad. How do I tune it to face correctly. Please see the attached picture. Smokey

What I noticed on bench is that when I try to pus the thrust, right front and rear left are starting first and half throttle all motors run and I checked the yaw, when give half throttle and do left yaw, left front motor and rear right motor spins which I assume is correct and it does vice...

I am not sure how it was setup when I bought it and not sure how to check that. Smokey

Yes, I did run through sensor calibration, I swear I used to fly with the same setup for a while and it started act like this only after I connected to open pilot and updated the firmware. Smokey

Here is my newly uploaded video Smokey

Hmm, My props all look correct like you showed in the picture. I think my ESCs are not calibrated properly and I noticed when setting my idle, front left always needs higher number to start. I tried to sync all ESCs several time but nothing is fixing it. I keep breaking props by flipping and...

Thanks for you response, Yes motors are turing correctly. What will be different in LibrePilot as compared to open pilot just asking because I never used that before. Smokey

Hello All, I am newb here, bought RTF QAV 250 knock off, update firmware and settings - not flying. My quad was flying but very sloppy so decided to install open pilot and update firmware and settings. Now the Quad will run all the motors but does not take off, when I give the full throttle, it...