Recent content by Shadow277

Upgrade to a better VTX, got it. Thank you for the explaination.

I have two cameras. The stock one for Eachine Racer 250. That one I am unsure if it works anymore. I bought a cheap FPV from Horizon Hobby. It has very short range. The only way to increase range is to buy a whole new VTX system. But how do I know if the Eachine Racer 250 VTX is broken?

Okay, so the only thing to do is buy a battery for my VTX system and see if it works? If not, buy a new receiver and camera?

The new one works. It just has like 10ft of range. :P So if the transmitter gets hot, could it still be broken? Should I just get a new camera and transmitter?

Sync: Get the camera to send video feed to my monitor that has the receiver. I'm still new but I must figure out what 5vt and 12vt means. What I do know is that the 600mw transmitter that I think broke does require a much higher voltage as opposed to the Horizon Hobby 25mw camera. The Horizon...

So why wouldn't the new camera work with my drone if I can get it to sync with my fpv gear? No camera can work when hooked to the power supply of my drone. How would buying a new transmitter and maybe a camera allow me to gain FPV?

Yes, the ESC is connected to the board with the transmitters and my battery plugs into it. The alternative is to get a seperate battery to power my VTX. I tried the 3.7V 150mili amps and could not power it.

So I noticed that a capacitor on my drone has been knocked off and I cannot find it after a crash. The VTX gains power but does not sync with my monitor. I tried a different camera by Horizon Hobbies and all it does is get hot. Would buying a new power board remedy this issue? If so, would I...

I think I have found the problem. One of the capacitors are missing! One is missing on the rear right. I feel very awful for not catching this. I suppose this is why the VTX receives power then? So I bought a Horizon 1100 all in one camera and power it with a 1s 3.7v battery. Now I can fly...

For very brief moments.

No. I also tried a new VTX on every channel and sti got nothing.

I have the RTF Eachine Racer 250. I did crash twice. I can get the bird to fly. I CANNOT get the monitor and camera to display FPV. I kept checking the wires, tried messing with video and channel settings, and I cannot get FPV to work. Does anyone have any suggestions? Thank you. EDIT: I forgot...

Just soldered two new ESCs and one new motor. For some reason, on the old motor, it keeps spinning even when I get off the throttle. Any ideas?

I apologize for asking such remedial questions; how do I connect the bird to my PC?

And if replacing older parts for new motors and ESCs, do I need to tune it via some PC sowftware?