Recent content by SeanPep

You don't need a receiver for the motors to spin up in BF... that is just sending a signal from BF to the flight controller. Connecting via USB doesn't touch your Rx. Same thing for the gyro. I'm not familiar with that Rx though but you might have to change some setting in BF for it to...

Yeah so when you arm the quad it should just spin the motors... not take off or anything. The reason you are having issues with keeping it from flipping and all that is because you're in air or arco mode. Angle mode will keep it level and make it easier to fly. Check out page 10 of the manual...

Did you set your transmitter up according to the book? My arm switch is on the right hand side of my radio but it's where ever you assigned it.

Like is there not a specific amp rating that you should use to discharge when using a charger?

Hey guys - fairly new and I have tried to do some research on this but I can't seem to find a straight forward answer. I have a SkyRC Q200 charger and I am trying to figure out what the "Discharge Current" should be set to for discharging and storage mode. My batteries are 3s 1550 mAH 75C...

So I just got a DX8G2 transmitter and a Conspiracy 220. Trying to get everything setup correctly and following the instructions. I have all the settings entered into the transmitter and got it bound but the issue I am having is when I arm it, with the throttle completely down mind you, the...

Hello everyone! My name is Sean and I am new around here. I've have a few "toy" quads and I've out grown them so I am looking at something a little more serious. Thought about going the build route but since my soldering skills are that great I figured I would go something already built. I...