Recent content by koklimabc

As topic quoted, does pixhawk flight controller (liked 2.48 and latest 6c) could be fit inside Geprc 7 inhces HD frame along with skyroid receiver? Thanks.

agreed.

Yes, agreed. My drone camera's was always keep me coming to see upon the sky(That is why I always failed into ground with unforeseen terrain). Is that possible to have drone stay in 45 angle instead of place in horizontal ground, then it will make my fpv's view to have seen more clearly on...

There is no problem to fly in LOS (Line of Sight) but It is totally difficult to fly in Pilot sight of view aka FPV and I always ended to flip over on first until three seconds. I'd attached a picture and what is it called from those highlighted in red circle (watermark?), does it help to...

Yea, I'd adjust all the settings to keep under range from 1000 : 2000. Hope It would be find later after real time trial flight :).

ok, I'll keep mind.

That is why I'd trying to adjust my "Radio's Output" to have yaw, pitch, roll with middle's endpoint set to 1500 along -70 % and + 70 % (Suit to me as beginner to behave press commonly the stick but actually produce lower 70 % output than actual 100 %). Besides that, I set my throttle starting...

I've try to undertand and follow the same on this video but this is a tinywhood, but I still do drifted onto left side after calibrated accel under my flight mode = Angle + Air mode.

I'd go far to test from just now. It also very difficult to pitch to fly forward and always dift to the left. I'm using Angle Mode + Air Mode (permanet enabled). Pitch Forward not working in real flight, need more help, TQ.

I do watch from his video before where you need to adjust offset values to get close to each other for under AUX 1. That say if I do share Turtle's (AUX 6) with GPS rescue mode, is it possible to work?

Yes, you are right and It is all about depending on receiver. FYI, I'm using Frysky R9 slim plus OTA under FCC type in FLEX FPORT firmware. I'd done checking from Fryskiy sites and it could supports upto "6/16 channel" with telemetry. What is means?

Yes, you are right. We need to prepare the spare parts for esc, prop, motor (I'd managed to put back metal magnet insider before and adjust back in position and seems to be work well) even another ready to fly drone as I learned from expert before.

Yes, you rights too. There is no easy to learn in acrobatic mode. It is been a lot of hilarious failing schemes happened againts me in past few days under my few maiden flights. Few Example liked Hard to maintain altitude, throttle to jump high and various uncontrol scenarios.

Yes, you are right. I need to tried first time on acro mode. I finally beter understand I need to coupe with angle mode + air mode liked always the same working in Sim.

I'd tried to create GPS recues Mode on Radio's (AUX 10) with Betaflight (AUX 5), but It won't work. Betaflight seems to be support until channel 4 (AUX 4) and not more. Below is my Input & Mixer againts betaflight ( Working ) Arm (Radio - AUX 5) - AUX 1 (Betaflight) Turtle Mode (Radio - Aux...