I appreciate the link. We've seen and tried to do that type of calibration several times. I am not sure if we have a calibration or an arming issue. Maybe it is because we have a 4x1 ESC, but this method in this video hasn't been able to help us to get the motors spin.
In the video, the...
Hello. I am working on a class project to build a flight controller out of an arduino and a gyro. I have been watching a lot of videos on youtube, but I can't get any of my motors to spin.
I am using the multiwii config, a Flysky tx/rx combo, and a 4x1 racestar20 ESC.
My TX/RX are bound...
I think some of my problem might be wiring or some configuration setting I can't find. I realized today in Betaflight that under the Receiver tab that my AERT and Aux values never change when I move the sticks on my TX.
I'm trying to use PPM for now, since I figured 1 wire would be easier...
Thank you for the replies!
Yes, I already have motors, batteries and props.
I'm trying to figure out the ESC calibration. I have the data sheet which gives a beep pattern based on with it is armed or in calibration mode. I've never been able to get it to arm or respond to my calibration...
Hello everyone! I am a college student and for a project we are working on building a quadcopter. Eventually the goal of the project is to take off the flight controller and build our own. But for now we are just learning about them in general. We are trying to build our first quadcopter...