Hello, i am new to frsky as i only have been using flysky tx and rx. Recently i bought a taranis x9 plus from ebay for 80 pounds. I succesfully binded both rx and tx and got solid green light. You can see all of my betaflight and tx settings in the attached pics. But i dont get any response in reciever tab. Could anyone help me with that. Again, i am using xm+ rx. Please help with the issue.
Taranis x9, no movement in reciever tab in betaflight.
- Thread starter Yarillo
- Start date
-
- Tags
- begginer new guy new member taranis
Total_noob354
Member
Have you looked on the flight controllers info page to make sure your receivers signal type (eg. Ppm) is compatible with it?
Are you sure the receiver wires are going into the right place on the flight controller? Some fcs have certain receiver types bound to a UART
Are you sure the receiver wires are going into the right place on the flight controller? Some fcs have certain receiver types bound to a UART
wafflejock
Well-Known Member
In the configuration tab under receiver protocol think you should have frsky selected not spektrum, spektrum is a competing company with frsky and the protocols aren't compatible as far as I know.
wafflejock
Well-Known Member
The ports tab serial rx selection, and configuration tab receiver option both need to be correct to see stick motion in the receiver tab.