I'm new to the rc world and I started with syma x5c-1 a few days ago yesterday while I was flying it at a Street basketball court It got a hit from the fences It wasnt the first time though It happened a lot and nothing went wrong after but this time my quadcopter went dead no lights no spinning nothing I recharged both my batteries 600 Mah and 500 Mah but again there were No lights It was dead please Help I want to Enjoy more from this quadcopter
Syma X5C-1 Power Issue Help!
- Thread starter Perseus
- Start date
The good news is that about anything is fixable on them.
You need to open it up and look for a broken wire or broken solder joint, it sounds like it is the main power, so if you have it try using a continuity tester. to see if traces are broken, if you find a broken solder joint on the PCB you are able to LIGHTLY sand the green protective layer (solder mask) off on both sides of the break, and put some solder to bridge the two sides.
PS: where do you live it is 5:00 am here haha
You need to open it up and look for a broken wire or broken solder joint, it sounds like it is the main power, so if you have it try using a continuity tester. to see if traces are broken, if you find a broken solder joint on the PCB you are able to LIGHTLY sand the green protective layer (solder mask) off on both sides of the break, and put some solder to bridge the two sides.
PS: where do you live it is 5:00 am here haha
I think I have found the problem the black cable at the on-off switch seems to be disconnected Can this be the problem mate?
Yeah, just make sure it is the correct cable, if you have two disconnected (one hot one ground) and switched the two it could fry it when the switch gets flipped. If only one broke wire then it should be fine to connect.