all this is new to me. i have a 450 quad with kk2.2.15 and a dx6i. my question the buttons on the dx6i the trim buttons. if the quad drifts to the right what tab to use to correct that same goes for if it goes toward me are away from me. also are u able to take your finger off of the right stick and would it hover by its self. thanks.
Ref dx6i
- Thread starter joseph
- Start date
AustinWulf
Member
Yes, is the quadcopter is drifting to the right when facing away from you, you can adjust for it by clicking the trim control below the right joystick to the left.
Do this as many times as necessary until the quad is hovering in its place. Keep in mind that there may be a slight breeze causing the quad to drift, so it is advisable to do this inside (when safe).
Do this as many times as necessary until the quad is hovering in its place. Keep in mind that there may be a slight breeze causing the quad to drift, so it is advisable to do this inside (when safe).
Hi mate Austin is right , but first please check that in the monitor screen of the kk all inputs are at zero the only one that will not ever read zero is aux, all the other must be zero ,use sub trim in the DX6i to get them to read zero ( make sure all face trims on the front of the DX6i are centre) if you do find the inputs are not zero and you adjust them recalibrate the board, then use the face trims to settle the quad to a nice hover , but your find it will hover well ,also flash with steveis1.8s1pro its a much more stable coding for the KK
AustinWulf
Member
Hi holtneil, I am setting up my DX6i for use with my quadcopter. I just posted a thread asking for help. Do you have any experience with the DX6i? If so, could you answer to that thread?
AustinWulf
Member
great! thank you