Crashed my QX350-3 and swapping the parts over to a Rakon Heli Carbon Fibre frame. In the crash a single grey wire from the body traveled down the landing leg opposite the side the compass wiring is on. That wire broke off and I don't know where to reinstall the broken wire. There is a small circuit board with two grey antenna wires coming out of it but I don't know if they were connected to the one that broke?
Also: There is a wire from the extended GPS mast that was just laying across the sheilded GPS module. Did that wire come from the module or is it just meant to lay on top of it?
I can't complete the assembly till I know where to place these wires.
Also: There is a wire from the extended GPS mast that was just laying across the sheilded GPS module. Did that wire come from the module or is it just meant to lay on top of it?
I can't complete the assembly till I know where to place these wires.