Hi there.
I am assembling a quad with pixhawk 2.4.8 flight controller and flysky fs-ia6 receiver, fx-i6 transmitter. I have ser this up with a ppm encoder between receiver and rcin on the pixhawk.
The problem is that I can't seem to get the transmitter to talk to the pixhawk (the ppm encoder has a fast flashing red light, if this means anything).
The transmitter is bound to the receiver and ppm is enabled on the transmitter. I am using the latest copter firmware and attempting to set up using mission planner. All calibration works well up to the radio calibration step, at which point the green bars on the channels are visible, but do not move as I manipulate the transmitter controls.
I have read what I can to try to figure this out without bugging you all, but I'm at a dead end.
Any ideas would be much appreciated!
I am assembling a quad with pixhawk 2.4.8 flight controller and flysky fs-ia6 receiver, fx-i6 transmitter. I have ser this up with a ppm encoder between receiver and rcin on the pixhawk.
The problem is that I can't seem to get the transmitter to talk to the pixhawk (the ppm encoder has a fast flashing red light, if this means anything).
The transmitter is bound to the receiver and ppm is enabled on the transmitter. I am using the latest copter firmware and attempting to set up using mission planner. All calibration works well up to the radio calibration step, at which point the green bars on the channels are visible, but do not move as I manipulate the transmitter controls.
I have read what I can to try to figure this out without bugging you all, but I'm at a dead end.
Any ideas would be much appreciated!
