Newbie help with naza v2 problem

T

thorny97

New Member
I have only flown my dji f450 quad a couple of times, the issue I'm having is after about 5 mins the led starts continuously flashing red. I have checked the flight mode gps no problem there. I have checked the voltage of the battiers, using an old turnigy 3s 5000mha, and that is reading 11.72 volts on landing, my first voltage alert is set as standard which I think is 11.55v.

Once I land the red light goes off and it starts flashing green again. If I then take off has soon as it's in the air it starts flashing red again.

Any ideas and pointers are most welcome.

Thank you

Mark
 
Sounds like you may be putting too much draw on the battery. What is the discharge rating (xxC) on the battery? This happened to me a few times when using batteries with lower discharge rates at higher throttle levels.
 
Thinking your voltage warnings are a tad conservative. I have mine set at 10.8v and 10.4v or so. Also, you will see some flashing red during power surges.
 
Back
Top