tristan davies
New Member
i have a dji f550 with a taranis 9xdplus with a 8xd reicever
i have at the moment some led strips on all sides of my arms plugged directly straight to balance port on a 3s 11.1v lipo
i want to control these by a control switch on my tx i orded one of these from brc hobbies
RC Lander Receiver Controlled Electronic On/Off Switch
[421686]
but cant get lights to turn on/off i have set the +/- 100% etc in tx
i reckon theres about 12meters strip all together 2m amber 2m blue 4red 4m green
also i want to create new leds and have assigned to other switches via method i bout 4 green at 3.3 and 4 white at 3.3 and 4 red 2.0 volts
and bought a resistor i put supply volage as 11.1 and it gave me a 300 resistor am i right in thinking the supply voltage should have been 5v from reicever also whats the best way to wire these or so on as i am looking at a few different sets to enable on switches am a novice to making led sets
at the moment wired them up to a switch as above and can switch these on/off via tx but they dont seem that bright for what i want as these are to simulate nav lights at switch of button theres only one resistor to all the leds but i belive this is the wrong one
any help or suggestions would be great
will try post pictures tommorow
i have at the moment some led strips on all sides of my arms plugged directly straight to balance port on a 3s 11.1v lipo
i want to control these by a control switch on my tx i orded one of these from brc hobbies
RC Lander Receiver Controlled Electronic On/Off Switch
[421686]
but cant get lights to turn on/off i have set the +/- 100% etc in tx
i reckon theres about 12meters strip all together 2m amber 2m blue 4red 4m green
also i want to create new leds and have assigned to other switches via method i bout 4 green at 3.3 and 4 white at 3.3 and 4 red 2.0 volts
and bought a resistor i put supply volage as 11.1 and it gave me a 300 resistor am i right in thinking the supply voltage should have been 5v from reicever also whats the best way to wire these or so on as i am looking at a few different sets to enable on switches am a novice to making led sets
at the moment wired them up to a switch as above and can switch these on/off via tx but they dont seem that bright for what i want as these are to simulate nav lights at switch of button theres only one resistor to all the leds but i belive this is the wrong one
any help or suggestions would be great
will try post pictures tommorow