Need some help please.

B

bloodbath9798

New Member
I finally got everything hooked up, tested all esc and motor combos, and then i hooked all up to the board. flying a kk2.1.5 stock from china and its kinda strange but not too crazy. asking for a donation on the top of the board is kinda weird and random lol's places but the board seemed legit. i try and fly it and most of the time the motors either pulse or dont work at all. i dont know whats wrong with it and i would really appreciate some help on the matter. thanks so much
 
Also i checked all of my solder joints and they are fine. i tested each motor and esc with just the rx and this is still happening and they have all been calibrated
 
Hi mate , first make sure the transmitter is set up Aero not heli , throttle curve is a 0 to 100 line , no mixing of any type , the kk motor load must be the right one X for X frame + for + its easy to get this wrong
Now if it has the HK firmware reflash it with steveis1.8s1pro firmware ( your need the flash tool for this )
Once all this is done go in to the monitor screen on the kk and make sure everything reads zero ( aux will not so leave this one alone)is any does not use sub trim in the transmitter so they all do .
Now your ready to test control move sticks on transmitter and this will show on monitor screen so left ,left will show etc
Now make sure quad is level and calibrate sensors all will come back as OK if not then the board is duff
Dont mount props yet test the quads at 1/2 throttle if you tilt quad forward the front motor will get faster and backs will slow down
Make sure motors spin the right way, front left cw front right ccw ,back left ccw , back right cw
 
I also ordered an open pilot cc3d board to try out.so far I haven't seen anything bad about it and I'm pretty excited to get it in. Let me know what you think about it. Thanks
 
Hi mate never used one but hear good things about it , its like the nase32 that board works well on default settings
 
Back
Top