Hi
This is my first build.(& first time on the forum)
I am using
LiPo: 2,200mAh 3s 25-35c
4x Brushless Escs: 20A continuous 30A burst 2-3s linear BEC 3v 5A
4x Brushless Motors: Max-Amp. draw 16A Max-Watt 190w 2-3s
hobbling 20A power distribution board
Naze32 Rev5 Full
BEC is being used on two of the Escs. When I power it on all but 1 or sometimes 2 motors will spin when I do calibration or will stutter spin. It carries from time to time. A solution to this would be much appreciated, Thanks.
This is my first build.(& first time on the forum)
I am using
LiPo: 2,200mAh 3s 25-35c
4x Brushless Escs: 20A continuous 30A burst 2-3s linear BEC 3v 5A
4x Brushless Motors: Max-Amp. draw 16A Max-Watt 190w 2-3s
hobbling 20A power distribution board
Naze32 Rev5 Full
BEC is being used on two of the Escs. When I power it on all but 1 or sometimes 2 motors will spin when I do calibration or will stutter spin. It carries from time to time. A solution to this would be much appreciated, Thanks.
