Killed 3 flight boards..not even taken off

Shortshortie

Shortshortie

New Member
Please help,

I have killed two sp3 and one naze rev6 flight boards and haven't even flown.

I Am running

30a Afro esc
Fpv
Gps
D4rii in ppm
Osd
4c battery

I hooked this all up to the Afro and all was good until I armed the board and tried to take off.
The front Of The quad went up first then all the esc lost signal from the naze.

Now the stm32 is mega hot when plugged in by either battery or USB....

How can I kill 3 boards??
 
Are you powering your board from just one esc or all 4 of them? Also get a magnifying glass and carefuly inspect every solder joint on your board.
 
5v is 5v I never had a problem on all my rev6 using all 4 bec off ESC's . Just saying. I always check the board works b4 & after I solder the pins. Then make sure everything is plugged in the right way. What type of pdb are you using. Sure it's not hooked upto 12v or some have an adjustment screw & it may need tweaking a little but you will need electric multimeter or continuity tester. You should already have one of these anyway, rev6 boards are easily killed through crashes. Now I can fly a bit I'm stepping upto the Kombini fcb as soon as my last 2 naze's are toast.
 
Back
Top