Is this even possible? Need suggestions on motor etc.

[mek]

I have a z600-v3 quadcopter (320 grams and 600 mm) frame:

http://www.hobbyking.com/hobbyking/...h_Mid_Crab_Landing_Gear_600mm_White_Red_.html

We were looking to have an extra payload on this quadcopter (around 2 lbs not including components). I am struggling to come up with a good motor/prop size/ESC and battery combination for this.

We have been using http://www.ecalc.ch/ to get a basic idea but its been crap so far. Any suggestions or places to start?

 

[GJH105775]

I have a z600-v3 quadcopter (320 grams and 600 mm) frame:

http://www.hobbyking.com/hobbyking/...h_Mid_Crab_Landing_Gear_600mm_White_Red_.html

We were looking to have an extra payload on this quadcopter (around 2 lbs not including components). I am struggling to come up with a good motor/prop size/ESC and battery combination for this.

We have been using http://www.ecalc.ch/ to get a basic idea but its been crap so far. Any suggestions or places to start?

Two options would be, low KV/big prop combo or going with an x8 setup.

 

[GJH105775]

Take a look at these. Not necessarily suggesting them just yet, but you may like what you see.

 

[mek]

Really helpful. Thanks! I ended up using APC 13x4 props and 800kv motors.

 

[GJH105775]

Really helpful. Thanks! I ended up using APC 13x4 props and 800kv motors.

Be sure to post some flight time test hahaha.

 

[SpaKteL]

How large esc you are going to use for 800kv motor?