I need some help BBAD
Member
I got my wizard x220s yesterday I’ve set up my fs i6x. Set up my switches and channels. 10 channels everything works fine when I check my onscreen display and set input to ppw and sbus. Rechecked it. Than I binded the fsa8s receiver fast blink held bind powered on rc slow flashing red light turned off both plug in usb it flashes slow try to bind controller still wouldn’t bind. But when I just turn the radio on the receiver light stays solid so I figured that was good atleast. Looked at numerous videos read threads forums tried everything still won’t bind hooked it up to beta flight . By the way I’ve never had to use beta flight before. Hook drone up to beta f moving the drone around and setting it flat and everything was where it’s supposed to be gathered from the many videos I’ve watched up people doing stuff to other versions of the wizard but this one I got has omnibus f4 v3 which is normal but the vtx looks different than any other video it does not have a digital display and just to throw this in there just powering drone to try to figure out why I couldn’t get binded it got pretty hot don’t no if this was normal. I did as best I could with beta flight and did as much as I could seeing how I couldn’t get the controller to show up or move anything. I accidentally hit the boot button while I was trying to bind and don’t no if that did anything wrong and I flashed firmware went back in and there wasn’t much under the cli part rechecked everything repeated that process again and again and again and I still can’t get the transmitter to bind to my quad I don’t no if I did something wrong or missed something or it’s defective but everything looks fine I can send pic if needed but I’m dying to get this thing in the air and really need some advice better than Google and YouTube can provide
