Help with Naz 32rev6 full / Spectrum spm4648 satalite receiver and DX6i

[Mark Scott]

Went through everything on cleanflight to setup Naz3 rev6 with spectrum spm 4648 sat receiver. Firmware flashed ok , receiver bound (autobind) motors run via usb connection. At the receiver page with my Dx6i tx on - throttle is normal - yaw shows roll - no elevator and no rudder response. I am at a dead end here. The Spectrum receiver is connected to the dedicated serial port.
Need help

 

[holtneil]

Hi mate some Dx6i were only dsm2 ,I hope your is dmsx

 

[Mark Scott]

Thanks for the reply. If my DX6i (no x after the i) is dsm2, would the spectrum spm4648 rx still bind?
Thanks in advance
Mark

 

[holtneil]

Hi you need the check the modulation on the transmitter you should be able to set to DSMX or DSM2 make sure your on DSMX then re bind the sats

 

[Mark Scott]

Thanks for your input. Checked my tx - DSM2. Found a link - removed sat grey wire from dedicated spectrum port connector (left pos and neg in) - connected signal wire to #4rx pin and that corrected the connection problem.
I'm not done, but now I know I can use my dx6i with the spm4648 satalite receiver.

Thanks again

 

[holtneil]

Well done thats great news