HELP..First Flight issues

C

Colby Au

New Member
Hi,

Newb here, working on my first quadcopter build, but having some issues with it, namely I get the following 'spin' issue when trying to lift off.


Have not tried to 'punch it' as it will result in a one leg flip backwards.

Specs on the build are as follows:
Frame: Composite ZMR250 Clone Frame (Carbon Glass Fibre)
Motors: 4 x GLB 2204-2300Kv
ESC: SimonK 12A Generic (unknown)
Flight Board: Flip32/Naze32 10DOF (Running Cleanflight)
Receiver: FrSky D4R-II, CPPM
Props: 6" Carbon Fibre Composite 6030
PDB: Home made power distribution cable
Battery: 3S Lipo Nanotech 1300 45-90c

Have done the following:
Checked all soldering connections
Checked Prop direction
Checked motor spin direction
Re-calibrated Flight board
Original flight computer swapped (CC3D to Flip32/Naze32 10DOF)

Not sure where to troubleshoot next. Please help.
 
Looks like you need to check that your ESCs are plugged into the board correctly and more likely that one motor needs to be reversed. To reverse a motor simply switch any of the two of three wires between the ESC and the motor.



Code: 
CW======CCW
   || ||
CCW=====CW
 
Also check your prop nuts to make sure the prop is spinning as fast as the motor. ry switching the opposite motor to that one and see if the results change.
 
Hi mate also make sure they are calibrated right and the right motor is plugged in to the right output from the FCB if 2 motors are wrong your get this spin, the motor set up on the FCB will be the X quad set up unless it has a H frame set up in the menu
 
I had the same thing when I got my new Taranis Transmitter. When I connected it to a working Blade 180 I couldn't get one of the motors to operate under throttle but putting other inputs in I could get the motor to operate. Long story short had to reverse the Yaw/Rudder direction
 
Back
Top