Hello.

T

troussos

New Member
Hello, Everyone.
I just acquired a DJI Flame Wheel F550 hexacopter with NAZA v2 FC and GPS with a Spektrum 8000 X receiver.
 
Thanks. I had a bit of a challenge circumventing the dressed Win10 unsigned certificate hurdle...now...on to the choppers.

The NAZA v2 assistant software sees the transmitter, but the motors are not responding to the transmitter.
 
Your need to arm the motors you can have arm not spin or arm with props spinning , look at the dji phantom 1 manual the naza FCB is the same so arming should be the same I think it's both sticks down and towards each other but check this it's been a long time back when I set up a naza FCB
 
You must log in or register to reply here.
Back
Top