H-430 Torpedo Quadcopter for sale special for this forum $300.00

DIY Drone

DIY Drone

Active Member
CUSTOM BUILT-DESIGNED FOLDING DRONE​
Up for sale is a Almost Ready to fly 430 size quadcopter with mini KK2.1 flight controller,4-MT2216-800kv motors,4 - 20 amp ESC with extended soldered wires, 4 - 9047 props(2cw - 2ccw), 6ch receiver, 3-cell 3000-mah lipo battery, and landing gear. This package includes everything you need except for the radio and charger to get flying. You can add your own camera. This quad is very stable and flies very nice. We recommend this multirotor for both beginners and advanced pilots. For longer flight time you can add a bigger battery.
The unique features about this drone are that it folds up for easy carrying out to the field. The handle provides a very nice way to carry it at the same time protecting the electronics. There is a lot of room to add FPV or GPS. The modular design can accept any custom flight controller, or electronic device you want to add or replace. It is very easy to repair, fly and has the best orientation on the market for new fliers to see from a distance. You will be able to tell which way it is heading, or coming, or going as you learn to fly. The durable material it is made out of has a wood finish.
KK2.1.5 Flight Controller:
The original KK gyro system has been updated to an incredibly sensitive dual chip 3 Axis gyro and single chip 3 axis accelerometer system making this the most stable KK board ever and allowing for the addition of an Auto-level function. At the heart of the KK2.0 is an Atmel Mega324PA 8-bit AVR RISC-based microcontroller with 32k of memory. An additional 2 motor output channels have been added to the KK2.0 allowing for a total of 8 motors to be controlled (Octocopter).

Specs.
Weight: 16 gram
IC: Atmega324 PA
Gyro: InvenSense Inc.
Accelerometer: Anologue Devices Inc.
Auto-level: Yes
Input Voltage: 4.8-6.0V
AVR interface: standard 6 pin.
Signal from Receiver: 1520us (5 channels)
Signal to ESC: 1520us
FIRMWARE VERSION: 1.9\
This almost ready to fly quadcopter comes fully assembled and configured. It includes everything you see in the pictures. For shipping we remove props.
To fly it all you need to do is provide your own transmitter and balance/charger.
Package Contains:
ARF 450mm QuadCopter
Mini KK 2.1 FC
6ch RX DSM2
4-MT2216-800 kv
4- 20 Amp Afro ESCS
4- 9 X 4.7 Props(2 cw - 2 ccw) (Colors may vary)
3 cell 3000mah Lipo battery with xt60 fitting connector
Low Voltage Alarm
Lost Model Alarm
All Necessary Hardware
Weight with battery is about 1400g and flight time is about 10 minutes
We custom build other multirotors/drones if you are looking for something different.
Please note we custom build these and it may take up to 7 business days before we ship. 80% of the time we ship within 3 days. We test fly all multirotors prior to shipping to make sure everything is working correctly. Due to the nature of this hobby we do not except returns.
20151119_173635_51437_zpsjtxrpfes.jpg

20151122_151840_zpslolezmjb.jpg

20151121_174415_zpsdd55y5ea.jpg
 
Last edited:
DIY Drone said:
CUSTOM BUILT-DESIGNED FOLDING DRONE​
Up for sale is a Almost Ready to fly 430 size quadcopter with mini KK2.1 flight controller,4-MT2216-800kv motors,4 - 20 amp ESC with extended soldered wires, 4 - 9047 props(2cw - 2ccw), 6ch receiver, 3-cell 3000-mah lipo battery, and landing gear. This package includes everything you need except for the radio and charger to get flying. You can add your own camera. This quad is very stable and flies very nice. We recommend this multirotor for both beginners and advanced pilots. For longer flight time you can add a bigger battery.
The unique features about this drone are that it folds up for easy carrying out to the field. The handle provides a very nice way to carry it at the same time protecting the electronics. There is a lot of room to add FPV or GPS. The modular design can accept any custom flight controller, or electronic device you want to add or replace. It is very easy to repair, fly and has the best orientation on the market for new fliers to see from a distance. You will be able to tell which way it is heading, or coming, or going as you learn to fly. The durable material it is made out of has a wood finish.
KK2.1.5 Flight Controller:
The original KK gyro system has been updated to an incredibly sensitive dual chip 3 Axis gyro and single chip 3 axis accelerometer system making this the most stable KK board ever and allowing for the addition of an Auto-level function. At the heart of the KK2.0 is an Atmel Mega324PA 8-bit AVR RISC-based microcontroller with 32k of memory. An additional 2 motor output channels have been added to the KK2.0 allowing for a total of 8 motors to be controlled (Octocopter).

Specs.
Weight: 16 gram
IC: Atmega324 PA
Gyro: InvenSense Inc.
Accelerometer: Anologue Devices Inc.
Auto-level: Yes
Input Voltage: 4.8-6.0V
AVR interface: standard 6 pin.
Signal from Receiver: 1520us (5 channels)
Signal to ESC: 1520us
FIRMWARE VERSION: 1.9\
This almost ready to fly quadcopter comes fully assembled and configured. It includes everything you see in the pictures. For shipping we remove props.
To fly it all you need to do is provide your own transmitter and balance/charger.
Package Contains:
ARF 450mm QuadCopter
Mini KK 2.1 FC
6ch RX DSM2
4-MT2216-800 kv
4- 20 Amp Afro ESCS
4- 9 X 4.7 Props(2 cw - 2 ccw) (Colors may vary)
3 cell 3000mah Lipo battery with xt60 fitting connector
Low Voltage Alarm
Lost Model Alarm
All Necessary Hardware
Weight with battery is about 1400g and flight time is about 10 minutes
We custom build other multirotors/drones if you are looking for something different.
Please note we custom build these and it may take up to 7 business days before we ship. 80% of the time we ship within 3 days. We test fly all multirotors prior to shipping to make sure everything is working correctly. Due to the nature of this hobby we do not except returns.
20151119_173635_51437_zpsjtxrpfes.jpg

20151122_151840_zpslolezmjb.jpg

20151121_174415_zpsdd55y5ea.jpg
Click to expand...


300$? How are you even paying for your cost hahahaha
 
Im not. All I want for Christmas is one Drone sold so they can tell me how much they hate it or like it. :(

I did change the video so it shows the 430.
I still have to mess with the settings on the 650.

20151216_171928_zpsjgjjbmqw.jpg

This is the 430 next to the 650. I love this design. Look I have more room for more drones. :)​
 
Last edited:
Sure looks like it flies nice. Appeared to be very stable. Wish I had the extra $300 to take you up on your offer.
 
Well my friends, Sold one to cobra. He should be getting it today. I tried to give him as much information as I could so he could enjoy his flying.
I will post a video on Monday of some flights I took around the house today on Saturday with my own H-430 Torpedo.
As you may have guess I was laid off a week before Christmas. It has been a struggle to figure out what to do with the rest of my career now that Oil and gas have hit rock bottom. The rumor is 9 other major companies are planning to let a lot of workers go. My company is shutting down. Me and my wife are seeking to move to Austin to find a new line of work.
On the lighter side, I hope all of you had a Merry Christmas and a Happy New Year. Look for the video on Monday after it is processed. I am thinking that $300.00 is the magic number to move these things. Still haven't sold a kit yet.
 
Nice website and some excellent designs ... when I complete some of my existing projects, I may just have to take a serious look.
Best of luck with your enterprise, looks like a great start!!
 
You must log in or register to reply here.
Back
Top