jrob4654
New Member
My buddy and I just got Leader 3 RTF's from Full Speed. Bound to my Taranis X9D Plus without issue, setup my switches, then flew an indoor test flight. Was really excited to go start the tuning process at the park, until...
Buddy had an issue with binding his to his Taranis QX7. The process I had just successfully used didn't work. I couldn't bind my Taranis to his quad either. I told him it was his Rx, and we needed to troubleshoot it. He was unconvinced, so we successfully bound his Taranis to my quad.
Now, trying to re-bind to MY Taranis, the Rx is flashing lights that should signify successful binding, just like before. However, no signal is being received, and I can't get any communication either way.
WHAT HAPPENED?
I really don't want to have to install a new Rx cause I can't imagine how it could be messed up. I tried flashing new firmware on the stack, which didn't help. I even tried inverting my serial-rx signal, to no avail.
Any ideas on what else I should try?
(The Rx is the FSD Nano V2)
Buddy had an issue with binding his to his Taranis QX7. The process I had just successfully used didn't work. I couldn't bind my Taranis to his quad either. I told him it was his Rx, and we needed to troubleshoot it. He was unconvinced, so we successfully bound his Taranis to my quad.
Now, trying to re-bind to MY Taranis, the Rx is flashing lights that should signify successful binding, just like before. However, no signal is being received, and I can't get any communication either way.
WHAT HAPPENED?
I really don't want to have to install a new Rx cause I can't imagine how it could be messed up. I tried flashing new firmware on the stack, which didn't help. I even tried inverting my serial-rx signal, to no avail.
Any ideas on what else I should try?
(The Rx is the FSD Nano V2)