First Quadcopter building, problem with connecting

J

JanMarkD

New Member
I'm building a quadcopter with a KK2.1.5 and a 6ch Tx Rx. I've installed the programm for the KK and also for the transmitter. I can connect the transmitter and receiver, because the red light stops flashing if I push the 'blind range test' button on the receiver. But when I look on the KK2.1.5 and I go to Receiver Test it says: 'no signal'. When you start the KK2.1.5 it says no aileron input.

What do I have to do now?

I hope you can help me
 

Attachments

  • FullSizeRender (1).jpg
    FullSizeRender (1).jpg
    116.4 KB · Views: 2
  • FullSizeRender.jpg
    FullSizeRender.jpg
    145 KB · Views: 2
Hi mate how far apart was the transmitter and receiver when you bind, the min should be 6 feet this will give you the range then , sounds strange but they dont bind well close up , try it and let me know
also when I looked at the photo, have you still got the bind plug in , bind it then remove it before you do anything else , then test the range
 
I connected it, when the trasmitter was very close to the receiver. The strange thing is the light stops flashing (which shows they are connected) but it says no signal. Do you also know something about the 'no aileron input' problem?
 
Hi mate No never had that problem , check your set up , transmitter needs to be set as a aero no mixing , bind the receiver to the transmitter 6 feet or over , then go into monitor screen on the KK and reverse any channels that the sticks input dont match up to the monitor , also make sure all servo travel in the transmitter are at 100%
Check the servo leads are the right way on the board light colour wire is the signal wire , also change the servo wire and see if fault moves the wire may be bad
 
Back
Top