Everythink is connect but motor do not turn

X

xavier bernard

New Member
Hi everyone,
I'm new and I bought a JJPro P130 on an order and a FS-i6 in an other order, I connect both:
upload_2018-1-4_22-32-15.png

I install CleanFlight and when I test the receiver it's OK, I see on the screen when I use the remote.
when I go to Motors section in CleanFlight and I turn on motor, the motor turn on.

But when I disconnect from my computer and try to fly, I use the Throttle and nothing happend.
I do not know what I do wrong to make it work, if someone can help me.
thank you
Xavier
 
You need to arm the motors ,normally hold throttle down and right to arm most boards just check in clean flight what your arming signal is . Test with props off the be safe
 
Back
Top