Eachine Novice 4 crash repair

skyhi

New Member
Hi everyone, I'm a newbie and have had a few crashes with my Novice and up to this point no issues with repairs. However recently I replaced two motors and thought I would go onto beta flight to tamper with settings as I unknowingly had soldered the wires in the wrong order making motors spin incorrectly. After having resoldered two of the wires in the correct order everything seemed ok in Beta flight (motors spin to full capacity, switches AUX1 arm the quad on screen) but drone will not arm via the transmitter and unplugged from the pc. Not sure if I have touched a specific setting or could something have cooked or have been damaged on its last crash? Any Ideas guys? Much appreciated if someone could point me in the right direction
 
Check the modes tab for the arming mode and make sure when you move the switch the mode gets activated (make a range for chosen switch to activate given mode). Second thing if you have goggles turn the osd warnings on can often tell you what is wrong on screen or help diagnose the issue. Third thing would just make sure FC orientation seems good on the setup tab moving the quad around manually.
 
Check the modes tab for the arming mode and make sure when you move the switch the mode gets activated (make a range for chosen switch to activate given mode). Second thing if you have goggles turn the osd warnings on can often tell you what is wrong on screen or help diagnose the issue. Third thing would just make sure FC orientation seems good on the setup tab moving the quad around manually.
Thank you for the tips I really appreciate that. I know I’ve got the tabs range correct but I’ll have a look at the osd warnings on the goggles and the FC orientation... hopefully something will work.
 
Back
Top